Page 1 of 1

Pyronies

Posted: Wed Mar 05, 2014 10:51 am
by ununninty
Hey

Hi there I have just taken delivery of an x4 extender to treat Pyronies curvature. How do you know what tension you should start with and do you have a section in your website that deals with operational issues such as this.

Re: Pyronies

Posted: Wed Mar 19, 2014 9:27 am
by altelvibe
Hey

We i wont say i am and expert on extenders but i got mine for the same reason and what i did was to set up at a low tension by compressing the device only to the middle line on the bars and keep it there for a couple weeks then what i would do is unscrew the nobs at the bottom to extend the device and add some more tension